light room
light room
Who can help me take down the hall light to see if the pipe needs to be replaced because it no longer works. It's the long light next to the bathroom door. Thanks in advance.
Re: light room
Hi,
I don't understand which one light you refer but, ordinary only pull the lower side of the carter; there is no screw.
I just do it to inspect the 12V lighter socket.
I don't understand which one light you refer but, ordinary only pull the lower side of the carter; there is no screw.
I just do it to inspect the 12V lighter socket.
Re: light room
I think boatmen means the long vertical fluorescent tube at the sliding door. This is not easy to replace. Lots of parts have to be taken apart to access it. When mine was broken too, I had it replaced with a LED strip. This looks even better, as it reaches now to the very bottom.
Peter
Peter
James Cook 319 CDI 7G-Tronic (Modell 2006-2012) EZ 2012 3,88t
James Cook 316 CDI Sprintshift (Modell 2000-2003) EZ 2003 3,5t
James Cook 312 D Schaltung (Modell 1995-2000) EZ 2000 3,5t
James Cook 316 CDI Sprintshift (Modell 2000-2003) EZ 2003 3,5t
James Cook 312 D Schaltung (Modell 1995-2000) EZ 2000 3,5t
Re: light room
After reading the message of Peter; I understand that my light is defect . ( I never see it lighting ! )
I begin to dismantle to repare the light.
Note : I let the heater ON to avoid the breakage of the plastic by low temperature.
After sometimes, I understand it is very complicated and I do the same as Peter: I launch a wreath of 180 Led in the pilar and connect it.
Thje effect is perfect; the light illuminâtes the fridge; the power supply is very mow 1 A. (cost : 25€ )
I take some pictures and comment here : https://www.dropbox.com/s/53ygz677w18hw ... t.pdf?dl=0
The most complicated was to unscrew the 2 small screws pictures 3 and 4.
I hope this is helpfull.
I begin to dismantle to repare the light.
Note : I let the heater ON to avoid the breakage of the plastic by low temperature.
After sometimes, I understand it is very complicated and I do the same as Peter: I launch a wreath of 180 Led in the pilar and connect it.
Thje effect is perfect; the light illuminâtes the fridge; the power supply is very mow 1 A. (cost : 25€ )
I take some pictures and comment here : https://www.dropbox.com/s/53ygz677w18hw ... t.pdf?dl=0
The most complicated was to unscrew the 2 small screws pictures 3 and 4.
I hope this is helpfull.