I installed the inox exhaust line. The parts needed :
• 1m straight tube
• 1x over axle bend
• 2x 60° bend
• 55cm straight tube
• 4 brackets
• 1 suspension
- 1 - Ligne complète en pièces.jpg (99.88 KiB) 738 mal betrachtet
- 2 - Angle coudes 60°.jpg (97.41 KiB) 738 mal betrachtet
- 3 - Sortie.jpg (80.71 KiB) 738 mal betrachtet
I had to cut the first straight tube, which was soldered by the rust :
- 4 - Coupure tube.jpg (190.02 KiB) 738 mal betrachtet
- 5 - Tube 1m après silencieux.jpg (164.36 KiB) 738 mal betrachtet
- 6 - Chapeau de gendarme.jpg (152.49 KiB) 738 mal betrachtet
The first 60° bend part comes quite close to the spare wheel (3cm) I hope it will be OK. I couldn't do better, I've cut the parts at the shortest possible.
- 7 - Chapeau de gendarme et coudes.jpg (124.48 KiB) 738 mal betrachtet
- 8 - Sortie arrière.jpg (102.3 KiB) 738 mal betrachtet