Bathroom Faucet

[Fanny]

Anyone have any instructions to disassemble the bathroom Faucet?

I discovered, when I had no water flow in the bathroom, that a wire has disconnected from the internal water pump power switch.

I would like to get inside to solder it back together.

Thanks
Chris

[scandi]

Salut Fanny, vous verrez un message privé (PN)

Salutations Scandi

[jasonk]

Any chance you can forward me the details too please?
I have the same issue to attend to.

[Fanny]

Hello.
Its been a while now, and worse I didn't take photos during this surgery. However I will try to explain the steps.

1) Unnolt the sink from the wall. Ihave a 2001 generation JC do there is a single 10mm bolt holding the sink in place. Access to the bolt from the hanging cupboard behind the tissue covering the plumbing hoses.
2) carefully lift the sink off the hanging rails amd pise on your thighs. Carefully reach over sink and disconnect all the hoses...shower, hot cold and drain and disconnect the wires at the quick clip. CAUTION THE DRAIN HOSE CAN BE BRITTLE AND CRACK IF TOU TWIST THE SINK TOO MUCH.
3) remove sink assembly from van, remove faucet from sink
4)with a wrench remove the three hoses from underside of faucet
5)remove the red/blue plastic plug from faucet handle, insert 3 or 4mm allen key and unscrew pin. Remove faucet handle.
6) IF I RECALL the bottom plate to the faucet can be unscrewed and the internals all fall out.
7) solder the wire and put it all back together.

Chris

[Fanny]

Hello.
Its been a while now, and worse I didn't take photos during this surgery. However I will try to explain the steps.

1) Unbolt the sink from the wall. Ihave a 2001 generation JC do there is a single 10mm bolt holding the sink in place. Access to the bolt from the hanging cupboard behind the tissue covering the plumbing hoses.
2) carefully lift the sink off the hanging rails amd pose on your thighs. Carefully reach over sink and disconnect all the hoses...shower, hot cold and drain and disconnect the wires at the quick clip. CAUTION THE DRAIN HOSE CAN BE BRITTLE AND CRACK IF TOU TWIST THE SINK TOO MUCH.
3) remove sink assembly from van, remove faucet from sink
4)with a wrench remove the three hoses from underside of faucet
5)remove the red/blue plastic plug from faucet handle, insert 3 or 4mm allen key and unscrew pin. Remove faucet handle.
6) IF I RECALL the bottom plate to the faucet can be unscrewed and the internals all fall out.
7) solder the wire and put it all back together.

Chris

[jasonk]

Many thanks! That's perfect