Shower base flexes too much with a person's weight
Shower base flexes too much with a person's weight
As the title says, my shower base flexes a little bit too much on the corner under the sink, which means the silicone that's sealing the corner doesn't stick well to the wall. I was wondering if it's possible to access the area under the shower base in order to try to stabilize it. It looks like the back wall can be disassembled from the outside by removing the screws (including the 2 towel holder screws), can anyone confirm this? Thanks!
Shower base flexes too much with a person's weight
Die Rückwand lässt sich nicht demontieren!!
Du kannst nur die Duschwanne ausbauen und unterfüttern!!
Du kannst nur die Duschwanne ausbauen und unterfüttern!!
Alle sagten: Das geht nicht.
Dann kam einer, der wusste das nicht und hats gemacht
[/b]
) 316CDI EZ: 03.2006. Sprintshift. 2x 80 WP Solar Modul.
Dann kam einer, der wusste das nicht und hats gemacht
[/b]) 316CDI EZ: 03.2006. Sprintshift. 2x 80 WP Solar Modul.Re: Shower base flexes too much with a person's weight
Danke Epeg!
Is there any thread on this forum (ideally with pictures) that shows how to remove the shower base? It would be great to see what's under it and try to stabilize it better.
Is there any thread on this forum (ideally with pictures) that shows how to remove the shower base? It would be great to see what's under it and try to stabilize it better.
Re: Shower base flexes too much with a person's weight
JC 2003, 316 CDI, Automatik, Alaskaweiß, gelbe Einrichtung, 85 W PV Anlage, Hinterachse luftunterstützt, AHK, Mopedbühne, usw...
Mittlerweile >225.000 km
Mittlerweile >225.000 km