James Cook Forum

and it continues...
now that thé water pump is working and the tank is filled,
the rap/faucet in the bathroom is leaking. the red tube in the photo (which I expect is the hot water side)

it may be as simple as a replacement O Ring or washer.
or the rap might have frozen and is broken.

my seller told me this is a replacement tap as the original was damaged when hit.

So i might want to replace it anyway.

but to access it I expect I need to remove the sink.

how would I do that?
the sink tip seems a bit loose at the front edge - is it possible to remove the sink insert without removing the entire cabinet?

I removed the two bolts on the Left and Right sides.
and now the front corners and front edge of the sink seem loose.
but the back corner where the faucet sits, is still solid.

is there maybe some silicon caulking holding it in place, that I need to cut?

https://drive.google.com/drive/folders/ ... mV2-5lt1Zd

Den Spiegel solltest du auch noch anschrauben..Dann geht es einfacher.

In der Rückwand hinter den Hecktüren ist noch eine Schraube. Wenn die entfernt ist kannst du den kompletten Schrank nach oben ziehen.

faucet leak is corrected!

(problem was that the red line connector was not fully seated in the white part of the faucet. The Yellow pin was above the slot it was supposed to sit in. I just had to remove the yellow fixing pin, insert the red connector deeper, and reinsert the yellow pin)

I now know how these faucets work.

only remaining problem is that the water flow is very low (I think the screen is clogged up - I am soak it in vinegar)
AND
I am not getting an separation of the Hot and Cold water flows. There must be a problem with the mixing valve.

But since this faucet is still missing the Julia Shower handle, while everything is a part maybe I just order the correct faucet ("Reich Kama with Julia" I believe) and install the new one instead.

Peter