James Cook Forum

Good Evening from the UK. I recently replaced my Eberspacher with the above Webasto- with much help from Thomas T in particular. It is a good heating system. However I am having difficulty with the HD multi controller that regulates the temperature. If I set the temp on the controller to 20 degrees it gets much too hot before the remote temperature sensor shuts down the heating. In practice I have to set the temp on the controller to 15 degrees in order to achieve an actual temp of 21 degrees. Is this a problem anyone else has had? I can live with it but would oreferyto sort it out properly. The sensor is mounted in the grey kitchen block but moving the sensor on its long lead to the place of the original Eberspacher sensor makes no difference. So I can only think that either it is a faulty sensor or there is a problem in the wiring loom- but if it was the loom then I wouldn’t expect the heating to respond to temp changes- which it does. Any ideas before I contact Webasto? Adrian

Hello Adrian,

to reach a temperature of ca. 21 degrees in the car, i have to set the multicontrol to 18 degrees. I tolerate the difference.

Thanks Thomas. That is very helpful and confirms to me that the loom wiring is ok and that the difference is just to be tolerated. Adrian.