anti pinch panoramic sun roof / Klemmschutz Panoramadach

[Vtxbe]

My panoramic sunroff is now efficient but ... when I simulate the rain, the panel closes and then fully opens, just like the anti pinch function.
You have to close before a new test.
I try to reset by full closing + press 10sec but it doesn't change.

Some ideas ?

Happy new year

[Bosti]

Hi,

I've had this problem also in the past. In my case, the wind deflector was the problem. The resistance during closing the roof was to high because of leafs and dirt under the deflector. So look for any posibility to decrease the resistance during the final closing process. At both sides on the reflector guides was grease on my one. May you try the guides to lubricate with teflonspray for a better guidance.
In case of need you can also support the closing process with one hand on the sun roof bottom during pressing the close switch. I did it several times and the sun roof closed normal without any manual support.

Wish you success (and I hope the grammar was ok )
Bosti

[Vtxbe]

Thanks, Bosti

Finally I fixed the problem by half opening
Main red switch off 1 minute
Main red switch on
Full closing - maintain a few second - beep
Full opening - maintain a few second - beep

And it is smooth working.