James Cook Forum

Hi Jc freunde,

Because I have to renew the tap of the shower, I have to remove the wall located on the back of the rear seat.
The four screws are out.
When I try to move the panel, I feel something that maintain it in the red zone.
If I pull with more force, I think it will break...
Any idea how to do ?

Thanks for your help.

Hi spacy,
I don't have any access above the boiler to this tap.

Has someone already changed the tap of the sink?

Grussen aus Belgien

they are two masked screws they fit this panel
you feel them with a hook (pict 1); insert the hook between both panels
drill 2 holes (pict 2) + make the corner (in blue) smooth to avoid any sharp angle + do not unscrew fuse box if you do not remove the panel because there is a thin plate on the other side + do not drill the red cross marked hole ( this screw has no effect on the panel )
in my case , polyurethan glue has to be destroyed with a small hook ; I feel this not an original glue ( I'm 2nd owner )
rebuilding (pict 3)



And finally as announced by Spacy, I dn't have any acces to the tap. It is masked by the black shell that protects against water leakage